Lab Report must be typed. Lab report should be typed from the third person; in the passive form and in the past tense. Parameters for typed lab report: Font: , Size: Line Spacing: (The possibility to use the other programs rather than Microsoft Office to type lab reports can be discussed with the TA). Lab Report includes the following parts. Each part should be clearly marked in the lab report: Name of the experiment; Student’s name (prominent); lab partners’ names; Group Number (number attached to the lab computers); TA’s name; Section number (SLN/class number from ASU catalog). It is a statement of what physics concepts/theory/law was investigated or tested. physics quantities had to be measured? It is one or two sentences. only data that will be used in the further calculations. The experimental data should be tabulated. Tables should have appropriate headings and contain units. contains calculations of the the physics quantity that needs to be found to achieve the lab objective. All calculations have to be present with the equations. Equations to calculate uncertainties of the experiment should be also present. Microsoft equation is one of the programs that can be used for typing the equation. Other programs are also permitted. Results include the physics quantities . raw data and/or The final results should be organized in clearly labeled tables with their errors (if applicable). Results and uncertainties have to be reported with the correct number of significant figures and appropriate unit. This is one of the most important part of the lab report. Begin discussion with the purpose of the experiment. Briefly explain the physics theory/concept that was tested. State only the key/final results (with uncertainty and units) quantitatively with numerical values; does not provide intermediate quantities. Briefly explain the procedure that was used to collect the experimental data. Describe difficulties and shortcomings that were encountered during the experiment and it caused the uncertainties in the final results. Discuss “statistical errors” that affect your measurements, but which you can’t do anything about given the time and equipment constraints of this laboratory. Suggest experimental redesigns to eliminate and overcome these troubles. Include a description of sources of “systematic errors” in your measurement that bias your result (e.g. friction in pulleys that are assumed frictionless in the formula). Describe the qualitative effect of each source of error (e.g. friction slowed motion, causing a smaller value of acceleration to be measured). Describe only the prominent sources of error in the experiment. Address questions such as: Are the deviations in the experimental results due to uncertainty in the experimental method, or are they due to idealizations inherent in the theory (or both)? If the deviations are due to experimental uncertainties, can you think of ways to decrease the amount of uncertainty? Discuss how the apparatus could be redesigned to reduce uncertainties or to streamline experimental technique. If the deviations are due to idealizations in the theory, what factors has the theory neglected to consider? All questions from the Lab Manual should be also answered in the discussion section. The conclusion made if the objective of the experiment achieved. Overall the full lab report is expected to be about 4 pages+ title page.
https://helpinessaywriting.com/wp-content/uploads/2021/08/whatsapp-logo-300x115.jpeg 0 0 Help in essay writing https://helpinessaywriting.com/wp-content/uploads/2021/08/whatsapp-logo-300x115.jpeg Help in essay writing2019-07-11 20:08:202019-07-11 20:08:20Lab Report must be typed. Lab report should be typed from the third person; in the passive form and in the past tense. Parameters for typed lab report: Font: ,